Memorising The Remote Controls; General Information; Memorising The Keygo Io Remote Controls; Memorising The Keytis Io Remote Controls - SOMFY ROLLIXO io Manuel D'installation

Rollixo io

9 - MEMORISING THE REMOTE CONTROLS

9.1 General information

> Remote control types
There are two types of remote control:
- one-way: Keygo io, Situo io, Smoove io, etc.
- two-way with information feedback function (remote controls indicate the
io,Telis 1 io, Telis Composio io, Impresario Chronis io, etc.
> Memorising the remote controls
There are two ways to memorise a remote control:
- Memorising via the programming interface.
- Memorising by copying a previously memorised remote control.

9.2 Memorising the Keygo io remote controls

> Memorising via the programming interface
[1]. Press the button on the receiver until the indicator light comes on
Prog
permanently.
[2]. Press the outer left and right buttons on the remote control together.
[3]. Press a button on the remote control to be memorised within a maximum
time delay of 10 seconds.
The indicator light above button
control is memorised in the receiver.
[1]
Prog Prog
[3]
Prog
> Memorising by copying a previously memorised Keygo io
remote control
This operation is used to copy the programming from a remote control button
already memorised on the receiver.
[1]. Press the outer left and right buttons on the previously memorised remote
[2]. Press the button to be copied on the remote control already memorised until the
indicator light on top of the button on the receiver comes on permanently.
Prog
[3].
together.
[4].
control.
The indicator light above button
control is memorised in the receiver.
[1] [2]
Remote control memorised
[3] [4]
Remote control to be memorised
12
Prog
[2]
Prog
Prog
Prog

9.3 Memorising the Keytis io remote controls

The Keytis io remote control system key memorising and copy
memorising operations can only be carried out at the installation site.
To obtain authorisation to transfer its system key or programming,
the previously memorised remote control must be able to establish
radio communication with a receiver on the installation.
If the installation already includes other io-homecontrol® products
with at least one memorised two-way remote control, the Keytis io
> Memorising the system key
- This step must be performed if the installation already includes
other io-homecontrol® products with at least one memorised two-
way remote control.
control on the system, go directly to the step "Memorising the
remote control".
[1]. Setting the memorised remote control to key transfer mode:
- Keytis io, Telis io, Impresario io, Composio io remote controls: press the
"KEY" button until the green indicator light comes on (2 s).
- Other remote control: refer to the instructions.
[2]. KEY" button on the new remote control. Wait for the
Copyright © 2014 SOMFY ACTIVITES SA. All rights reserved.
Remote control to be memorised
Remote control memorised
Remote control to be memorised
Remote control
memorised