Checking The Direction Of Rotation Of The Motor And Adjustment Of The Motor End Limits; Edge With Xse Transmitter; Installing The Optical Radio Or Resistive Safety Edge And Its Xse Transmitter; Installing A Base Magnet On The Door Runner - SOMFY ROLLIXO io Manuel D'installation

Rollixo io
3.4 Checking the direction of rotation of the motor and
adjustment of the motor end limits
[1]. Press simultaneously on the
down movement occurs to enter motor adjustment mode.
Indicator light 1
1 2 3
STOP
[2]. Press button or to check the motor's direction of rotation.
- If the motor's direction of rotation is correct, move on to step [3] of the
motor end limit setting procedure.
- If the direction of rotation is incorrect, press button
up and down movement occurs, check the motor's direction of rotation
again and move on to step [3] of the motor end limit setting procedure.
1 2 3 4
STOP
Correct direction of Incorrect direction
rotation of rotation
Step [3]
[3]. If the motor end limits are already set, move on to step [8] to exit motor
adjustment mode.
If the motor end limits are not set, check that the motor is released: the
two push-buttons should be pressed.
Note: The motor end limits can also be set with a setting cable (ref.
9015971). In this case, set the motor end limits with the cable then
move on to step [8] to exit motor adjustment mode.
[4]. Press button to position the garage door in the upper position.
Adjust the top position using buttons
1 2 3 4
Prog
STOP
6
and buttons until the motor's up and
4
Prog
until the motor's
STOP
Prog
1 2 3 4
Prog
STOP
and .
[5]. Press the motor's upper end limit push-button.
or
[6]. Press button to position the garage door in the low position.
Adjust the bottom position using buttons
1 2 3 4
Prog
STOP
[7]. Press the motor's low end limit push-button.
or
[8]. Press simultaneously on the
until the motor's up and down movement occurs to exit motor adjustment
mode.
Indicator light 1 goes out.
1 2 3 4
Prog
STOP
or
1 2 3 4
Prog
STOP
4 - INSTALLING AN OPTICAL RADIO

EDGE WITH XSE TRANSMITTER

4.1 Installing the optical radio or resistive safety edge
and its XSE transmitter
Follow the instructions provided with the XSE transmitter and the optical or
resistive safety edge installation kit.

4.2 Installing a base magnet on the door runner

This is
presence of a bottom magnet makes it possible to:
- extend the battery life
- eliminate the risk of ground detection, to secure the closing of the
door
- automatically activate the maximum level of sensitivity of the
movement sensor
- increase the sensor operating time by 25 to 35 seconds when the
base magnet is detected.
Copyright © 2014 SOMFY ACTIVITES SA. All rights reserved.
and .
and buttons or press the button
Prog
for an optical safety edge. The