Memorising 3-Button Remote Controls (Telis Io, Telis Composio Io, Etc.) - SOMFY ROLLIXO io Manuel D'installation

Masquer les pouces Voir aussi pour ROLLIXO io:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Rollixo io
Copying individual buttons on the keytis io remote control
This operation is used to copy the memorisation of a single button on a previously memorised remote control to a blank button on a new remote control.
Ensure that the new remote control has memorised the system key.
[1]. Press the "PRoG" button on the memorised remote control until the green indicator light comes on (2 s).
[2]. Briefly press the button to be copied on the previously memorised remote control.
[3]. Briefly press the "PRoG" button on the new remote control.
Wait for the confirmation beep (a few seconds).
[4]. Briefly press the selected button to actuate the motorisation on the new remote control.
[1]
Remote control memorised
ItisnotpossibletomemoriseKeytisioremotecontrolsinthefollowingcases:
. The remote control has not memorised the system key.
. Several of the installation's receivers are in programming mode.
. Several remote controls are in key transfer or memorisation mode.
IncorrectmemorisationisindicatedbyarapidseriesofbeepsaccompaniedbyaflashingorangeindicatorlightontheKeytisremotecontrol.

Memorising 3-button remote controls (telis io, telis Composio io, etc.)

Button functions on a 3-button remote control
my
Complete opening
Stop
Memorising via the programming interface
To memorise a 3-button io bidirectional remote control (Telis io, Impresario Chronis io, etc.), ensure that the remote control has memorised the system key (see
page 18).
[1]. Press the
button on the receiver until the indicator light comes on
Prog
permanently.
[2]. Press the PRoG button on the back of the remote control to be
memorised within a maximum of 10 minutes.
The indicator light above button
remote control is memorised in the receiver.
Memorising by copying a previously memorised 3-button io remote control
To memorise a 3-button io bidirectional remote control (Telis io, Impresario Chronis io, etc.), ensure that the remote control has memorised the system key (see
page 18).
Copyright © 2012 Somfy SAS. All rights reserved
[2]
Complete closing
on the receiver flashes; the
Prog
2 s
Remote control memorised
[3]
Remote control to be memorised
[1]
Prog
Prog
Remote control to be memorised
[4]
[2]
Prog
19

Publicité

Chapitres

Table des Matières
loading

Table des Matières