Assembly Pantagruel - Extremis PANTAGRUEL Mode D'emploi

ASSEMBLY PANTAGRUEL

WHAT YOU NEED
2 people
no. 13 spanner
no. 4-5-6 hex key
+/- 45 min.
2. Assemble the wheels to the axles with 4 bolts M6 x 20
and flat washers M6. Use a 13 wrench when tightening
the bolts to secure the axle.
bolts, but do not fully tighten them.
4. Put the bench upside down on a table (use the
packaging as protection) & assemble the leg with 4
bolts M8x16 & the corrugated spring washers M8.
After the bench is assembled, you can tighten the bolts
of the base plate completely.
4 pantagruel
ATTENTION
: tighten the
1. Put the tabletop diagonally on the trestles. Loosen the
lazy susan by unscrewing the nut on the bottom of the
tabletop and by removing the stainless steel plate.
Remove the lazy susan.
3. Secure the support and the base plate (or the optional
floor fastening plate, with the hole directed to the
centre. Use the fixing media most suited to the type of
ground on which you intend to install the Gargantua
table.) to the leg with 2 countersunk bolts M8 x 25 but
don't tighten it completely yet. Repeat this for all the
legs.
5. Secure the leg with the bench to the tabletop with 4
countersunk bolts M10 x 25. After assembling the first
leg, mount the opposite leg to maintain balance.
Remove the trestles.
of