Troubleshooting - Ryobi P2501 Manuel D'utilisation

 Clean all foreign material from the product. Store
idle unit indoors in a dry, well-ventilated area
that is inaccessible to children. Keep away from
corrosive agents such as garden chemicals and
de-icing salts.
 Always place the scabbard on the saw bar
when transporting or storing the pole saw. The
scabbard is a snug fit and must be attached
PROBLEM
Bar and chain
running hot and
smoking.
Motor runs,
but chain is not
rotating.
This product has a Three-year Limited Warranty for personal,
family, or household use (90 days for business or commercial use).
For warranty details, visit www.ryobitools.com
MAINTENANCE

TROUBLESHOOTING

CAUSE
Check chain tension
for overtightened
condition
Chain tension too
tight.
Check guide bar and
chain assembly.
Check guide bar and
chain for damage.
or call (toll free) 1-800-860-4050.
very carefully due to the sharp teeth on the
saw chain. This is best done by grasping the
scabbard at one end, in the center portion of
the scabbard, and carefully sliding it over the
chain as shown. Use caution to avoid the sharp
teeth of the chain.
NOTE: The saw chain is very sharp. Always
wear protective gloves when handling the chain.
Tension chain. Refer to Adjusting the Chain Tension
earlier in this manual.
Retension chain. Refer to Adjusting the Chain Tension
earlier in this manual.
Refer to Replacing the Bar and Chain earlier in this
manual.
Inspect guide bar and chain for damage.
19 — English
SOLUTION