Fit The Blade Guard - Husqvarna WS220 Manuel D'utilisation

Fit the blade guard

1 Outer sections
2 Center section
3 Locking knob for blade guard
4 Blade guard guide
5 Blade guard guide lock Blocks the blade guard guide
for the blade guard .
6 Blade guard attachment. Is mounted on the
attachment for the saw unit.
7 Guide rollers
8 Locking wheels for outer sections
9 Guide pipes
10 Runners
11 Spray guard
WARNING! Never mount or dismount the
!
blade or blade guard without first pulling
out the power cable running to the saw
unit.
ASSEMBLING AND ADJUSTMENTS
The blade guard consists of three sections, a middle
section which is mounted on the saw unit as well as two
outer sections which are mounted on the middle section.
The outer sections are equilateral and may be fitted on
either side of the center section.
• Push the blade guard guide between the pipes on the
blade guard.
• Make sure that the guide rollers on the blade guard
guide roll easily between the pipes.
• If the blade guard guide has play between the pipes,
the guide rollers must be adjusted. See the section
'Adjustment of blade guard guide'..
Fitting the blade guard on the saw unit
Make sure that the blade guard is undamaged and that
the blade guard guide is mounted and centered on the
blade guard. In order to facilitate mounting of the blade
guard, the outer sections may be removed from the
middle section.
• Turn up the guide flange for the blade guard on the
saw unit so that the water connection is pointing
straight out from the pivot arm.
–
English 17