Cleaning And Caring For The Device; Disassembling; Cleaning - ResMed AirSense 11 Mode D'emploi

Cleaning and caring for the device

WARNING
Beware of electrocution:
Do not immerse the device, AC Adaptor or power cord in water.
Do not connect to power while the device is wet. Make sure that all parts are dry before
plugging it in.
If liquids are spilled into or onto the device, unplug the device and let the parts dry.
Always unplug the device before cleaning and ensure that all parts are dry before plugging it
back in.
Do not perform any maintenance tasks (eg, cleaning, changing the air filter) while the device is in
operation.
Clean the device and its components according to the schedules shown in this guide, to maintain
the quality of the device and to prevent the growth of germs that can adversely affect your
health.
Regularly inspect power cords, cables, and power supply for damage or signs of wear.
Discontinue use and replace if damaged.
Do not open or modify the device. There are no user serviceable parts inside. Repairs and
servicing should only be performed by an authorized ResMed service agent.
CAUTION
Do not use bleach, chlorine, or aromatic-based solutions, moisturizing or antibacterial soaps or
scented oils to clean the device, the humidifier tub or air tubing. These solutions may cause
damage or affect the humidifier performance and reduce the life of the products. Exposure to
smoke, including cigarette, cigar or pipe smoke, as well as ozone or other gases, may damage
the device. Damage caused by any of the foregoing, will not be covered by ResMed's limited
warranty.
Leave the humidifier tub to cool for ten minutes before handling to allow the water to cool and to
make sure that the humidifier tub is not too hot to touch.
The following sections will help you with:

Disassembling

Cleaning

Checking
Reassembling.
14