Before First Use; Assembly; Operation; Turning On/Off - SilverCrest SWEW 750 C1 Instructions D'utilisation Et Consignes De Sécurité

Protect the product against heat .
Do not place the product close to
open flames or heat sources such
as stoves or heating appliances .
˜ Before first use
Remove the packaging . Check if all parts are
complete .
During production, some parts are covered with
a thin oil film for their protection . Before first use,
operate the product without any batter so that
any potential residues evaporate .
Clean the product and its accessories (see the
"Cleaning and care" section) .
NOTE: The first few times the product is heated
up, a faint odour may be present . Ensure sufficient
ventilation in the area .
˜ Assembly
m
WARNING! Risk of electric shock. Before
installing/removing the plates 11 , 12 , 13 :
Disconnect the power plug 4 from the wall
outlet .
DANGER! Risk of burns. Do not change/
remove the plates 11 , 12 , 13 right after
operation . Let the product cool first .
Installing the plates
Open the lock 1 . Open the product .
Place the inner catch 10 of the chosen plate into
the large hook catches 7 .
Push down the plate until it clicks in place .
Repeat on the other side of the product .
10 GB/IE/NI
NOTES:
Install only plates of the same type .
Motif plate 11 : The hollow plate needs to be
installed in the bottom section of the product . The
other plate is installed in the upper section of the
product .
Removing the plates
Open the lock 1 . Open the product .
Pull the release levers 8 . Remove the plate .
Repeat on the other side of the product .
˜ Operation
Preparation: Grease both exchangeable
plates 11 , 12 , 13 with suitable cooking oil .
˜ Turning on/off
Turning the product on: Connect the power plug
4 to a suitable wall outlet . The red indicator 2
lights up .
Turning the product off: Disconnect the power
plug from the wall outlet . The red indicator 2
goes off .
Light indicator
Red indicator 2 on
Red indicator 2 off
Green indicator 3 off
Green indicator 3 on
NOTE: During operation, the green indicator 3
goes on and off from time to time . This indicates
that the product is reheating up to the baking
temperature .
Status
Product on .
Product off .
Product is preheating/
reheating .
The baking temperature
has been reached .