Starting Operation - Tecsis PEX10 Mode D'emploi

6. Packaging / 7. Starting, operation
6. Packaging
Has everything been supplied?
Check the scope of supply:
Completely assembled pressure sensors; with flush version PEX11, PEX14
„
including pre-assembled sealings and protection cap.
EC-type examination certificate
„
Inspect the pressure sensor for possible damage during transportation. Should there
„
be any obvious damage, inform the transport company and tecsis without delay.
Keep the packaging, as it offers optimal protection during transportation
„
(e.g. changing installation location, shipment for repair).
Ensure that the pressure connection thread and the connection contacts will not be
„
damaged.
In order to protect the diaphragm, the pressure connection of the instrument PEX11, PEX14 is
provided with a special protection cap.
Remove this protection cap only just before installing the pressure sensor in order to
„
prevent any damage to the diaphragm or the thread.
Keep the protection cap of the pressure connection thread and the diaphragm for later
„
storage or transport.
Mount the protection cap when removing and transporting the instrument.
„
7. Starting, operation
Required tools: wrench (flats 27 or flats 41), screw driver
Diaphragm test for your safety
It is necessary that before starting the pressure sensor you test the diaphragm visually, as this
is a safety-relevant component.
Pay attention to any liquid leaking out, for this points to a diaphragm damage
„
!
(not necessary for PEX15).
Check the diaphragm visually for any damage (PEX11, PEX14).
„
Warning
Use the pressure sensor only if the diaphragm is undamaged.
„
Use the pressure sensor only if it is in a faultless condition as far as the
„
safety-relevant features are concerned.
28 Betriebsanleitung/Operating instructions/Mode d'emploi/Instrucciones de servicio Betriebsanleitung/Operating instructions/Mode d'emploi/Instrucciones de servicio
GB