Introduction; Intended Use; Technical Data; Scope Of Supply - Rommelsbacher JG 40 Mode D'emploi

Introduction

We are pleased you decided in favour of this premium yogurt maker and would like to thank
you for your confi dence. Its easy operation will certainly fi ll you with enthusiasm as well.
To make sure you can enjoy using this appliance for a long time, please read through the
following notes carefully and observe them. Keep this instruction manual safely. Hand out all documents
to third persons when passing on the appliance. Thank you very much.

Intended use

The appliance is designed for preparing natural yogurt (normal household use only). Other uses or modi-
fi cations of the appliance are not intended and harbour considerable risks. For damage arising from not
intended use, the manufacturer does not assume liability. The appliance is not designed for commercial
use.

Technical data

Only connect the appliance to an isolated ground receptacle installed according to regulations. The rated
voltage must comply with the details on the rating label. Only connect to alternating current.
Nominal voltage:
Nominal power:
Protection class:
Standby consumption:
Number of portion jars:
Setting time range:

Scope of supply

Check the scope of supply for completeness as well as the soundness of the product and all components
(see product description page 2) immediately after unpacking.

Packing material

Do not simply throw the packing material away but recycle it.
Deliver paper, cardboard and corrugated cardboard packing to collecting facilities. Also plastic packing
material and foils should be put into the intended collecting basins.
Disposal/recycling
According to the Waste Electrical and Electronic Equipment Directive, do not dispose of this
product with your normal domestic waste at the end of its lifespan. Therefore, please deliver
it at no charge to your appropriately licensed local collecting facilities (e.g. recycling yard)
concerned with the recycling of electrical and electronic equipment.
14
230 V~ 50 Hz
40 W
II
< 0.5 W
8 (150 ml each) with screw caps
up to 18 hours
In the examples for the plastic marking:
PE stands for polyethylene, the code fi gure 02 for PE-HD,
04 for PE-LD, PP for polypropylene, PS for polystyrene.