afriso DTA 20 E Notice Technique page 54

6.2.6 Adjusting the medium
You can select one of the following liquids:
• Water (density 1 g/cm³)
• Fuel oil (density 0.84 g/cm³)
• Variable (density adjustable from 0.5 - 1.5 g/cm³)
Depending on the selected medium, the display shows the adjustment
ranges for the liquid level.
6.2.7 Setting the tank shape
If the geometry of the tank differs from the geometries listed, the informa-
tion must be taken from the bearing chart of the tank manufacturer.
You can select one of the following tank shapes:
• Linear
• Ball
• Horizontal cylinder
6.2.8 Diameter
If you have selected the tank shapes ball or horizontal cylinder, the menu
"Diameter" opens.
You can select the following values:
• Ball: 0 - 576 cm
• Horizontal cylinder: 0 - 800 cm
6.2.9 Adjusting the liquid level
The level depends on the medium entered. You can select the following
values:
• Water: 0 - 350 cm
• Fuel oil: 0 - 416 cm
• Variable: Depends on density
Adjusting a higher liquid level (for example 450 cm):
1. Press the upper or lower key (individual steps) or hold down the corre-
sponding key until you have set the required liquid level.
Commissioning
DTA 20 E
EN
21