afriso DTA 20 E Notice Technique page 53

6.2.2 Adjusting the contrast
You can select the following values:
• 0 % - 100 %
The contrast can be changed in increments of 5 %. Factory setting: 35 %
6.2.3 Resetting the product to the factory settings
6.2.4 Setting the measuring interval
You can select the following values:
• OFF
• 1 - 240 hours
Based on the individual values of the measuring interval (24 hours), the
development of the level over time can be visualised in the AFRISOhome
smart home app.
Setting a longer measuring interval (for example, 48 hours):
1. Press the upper or lower key (individual steps) or hold down the corre-
sponding key until you have set the required measuring interval.
The product is factory-set to a measuring interval of 24 hours. A higher
measuring interval can decrease the service life of the battery.
6.2.5 Radio Learn
You can connect the product to the AFRISOhome gateway (see "Con-
necting the product to an AFRISOhome gateway").
Commissioning
A
1. Hold down the upper key until the
product switches to the language
selection.
2. Press the centre key 2 x.
- The product displays the menu
factory setting.
3. Hold down the upper key until the
work "Reset" (A) is shown on the
display.
- A countdown of 5 seconds is
counted down on the display.
DTA 20 E
EN
20