afriso DTA 20 E Notice Technique page 51

4. Screw the connection piece (A) into the hole.
If the plastic flange does not have a hole, proceed as follows:
1. Dismount the plastic flange.
2. Drill a vertical hole Ø 10 mm through the plastic flange.
3. Remount the plastic flange.
4. Push the weight (C) and the hose (C) through the hole.
5. Screw the connection piece (A) into the hole.
6 Commissioning
6.1 Commissioning the product
 Verify that all prerequisites for operation of the product are met.
Commissioning
Initial switching on:
1. Press the lower key to switch on
the product.
- The product automatically starts
a measurement.
- The display shows the lan-
guages selection (see "Selecting
the language").
2. Press the upper or the lower key
to set the required language.
3. Press the centre key 1 x.
- The selected language is set
and the display changes to the
next menu setting.
DTA 20 E
EN
18