afriso DTA 20 E Notice Technique page 46

5.2 Mounting the product
Mount the control unit to the wall. Use the enclosed dowels, depending on the
type of wall.
 Verify that the control unit is mounted to an even, rigid and dry wall at eye
level.
 Verify that the control unit is accessible and easy to oversee at all times.
 Verify that the control unit is protected against water and splash water.
 Verify compliance with the specified ambient conditions.
1
5.3 Electrical connection
ELECTROSTATIC DISCHARGE
• Always earth yourself before touching electronic components.
Failure to follow these instructions can result in equipment damage.
INCORRECT HANDLING
The product may only be opened at the side at the battery compartment.
• Only open the product to insert or replace the 9 V monobloc battery.
Failure to follow these instructions can result in equipment damage.
Mounting
2
3
NOTICE
NOTICE
1. Mount the upper screw to the wall.
2. Fit the control unit.
3. Align the control unit.
4. Fasten the control unit by screw-
ing the bottom lug to the wall.
DTA 20 E
EN
13