Maintenance Table - Stiga HT 40 Li Manuel D'utilisation

13. MAINTENANCE TABLE

Intervention
MACHINE
Check all fasteners
Safety checks/check controls
Check the battery charge status
Recharge the battery
Cleaning the machine and the engine
Cleaning and lubrication of the cutting means
Checking for any damage to the machine. If
necessary, contact the authorised service centre.
Checking the cutting means
Sharpening the cutting means
Replacing the cutting-means
* Refer to the battery/battery charger manual.
** The operation must be carried out by your Dealer or an Authorised Service Centre
14. TROUBLESHOOTING
PROBLEM
1. Blade control lever
and safety switch
operated but the
machine will not start
2. The motor shuts
down whilst working
3. The cutting means is
stationary when the
blade control lever
and safety switch
are engaged
4. The cutting means
overheats whilst working
5. The cutting means
comes into contact with
a line or electric cable
PROBABLE CAUSE
Battery is not inserted or
is inserted incorrectly
Low battery
Hedge trimmer is damaged.
Battery is not inserted correctly
Low battery
Hedge trimmer is damaged.
Insufficient blade lubrication
-
Frequency
Before each use
Before each use
Before each use
After each use
After each use
After each use
After each use
After each use
-
-
Make sure that the battery is
inserted correctly (para. 7.2.3)
Check the battery status and recharge
if necessary (para. 7.2.2)
Do not use the hedge trimmer.
Remove the battery and contact
an authorised service centre.
Make sure that the battery is
inserted correctly (para. 7.2.3)
Check the battery status and recharge
if necessary. (para. 7.2.2)
Do not use the hedge trimmer. Immediately
turn off the machine
Contact an Authorised Service Centre.
Turn off the machine, wait until the cutting
means is stationary, remove the battery
and lubricate the blades (para. 7.4)
DO NOT TOUCH THE BLADE AS IT
MAY BE LIVE AND BE EXTREMELY
DANGEROUS! Grasp the machine using
the insulated rear handgrip only and
position it at a safe distance from yourself.
Disconnect the current that powers the
severed line or mains cable and remove
the battery before freeing the blade teeth.
EN - 11
Notes
para. 7.5
para. 6.2
*
para. 7.2.2
*
para. 7.3
para. 7.4
-
para. 8.1.1
para. 8.1.2
**
para. 8.1.3
**
SOLUTION
remove the battery and