Cleaning And Lubrication Of The Cutting Means; Nuts And Bolts; Occasional Maintenance; Cutting Means Occasional Maintenance - Stiga HT 40 Li Manuel D'utilisation

• Do not use aggressive detergents or solvents
to clean the plastic parts or hand grips.
• Do not spray water onto the motor
and electrical components and
prevent them from getting wet.
• To avoid overheating and damage to the
motor or the battery, always keep the
cooling air vents clean and free of debris.
7.4 CLEANING AND LUBRICATION
OF THE CUTTING MEANS
To increase the efficiency and working life
of the blades, clean and lubricate them
carefully after each work session:
Do not touch the cutting device until
the battery has been removed and the
cutting device is completely stationary.
• Place the machine in a stable
horizontal position on the ground.
• Use a soft cloth to clean the blades,
along with a brush to remove
more difficult dirt and debris.
• Lubricate the blades by applying a light layer
of specific oil, preferably the non-pollutant
type, along the upper edge of the blade.

7.5 NUTS AND BOLTS

• Keep all nuts, bolts and screws tight to be sure
the equipment is in safe working condition.
• Check regularly that the
handles are fixed firmly.

8. OCCASIONAL MAINTENANCE

8.1 CUTTING MEANS OCCASIONAL
MAINTENANCE
Do not touch the cutting means until
the battery has been removed and the
cutting means is completely stationary.
If the blades are used correctly, following all the
instructions provided, they will not require any
maintenance work and will not need sharpening.
8.1.1 Checks
Periodically check that the blades are
not bent, damaged or deformed and that
the screws are adequately tightened.
Adjustment of the distance between
blades is not necessary, as this is
predetermined by the manufacturer.
8.1.2 Sharpening
It is necessary to sharpen the blades when
the trimming performance decreases and
the branches tend to stick together.
For safety reasons, sharpening should
be done by an Authorised Service Centre
with suitable skills and equipment for the
job; without risking any damage to the blade
which would make it unsafe when used.
Always replace and never repair a
blade which has blunt cutting edges.
8.1.3 Replacement
The blade must never be repaired,
but must be replaced as soon as signs
of breaking are noted or the sharpening
limit is exceeded. For safety reasons
replacements should be performed
by an Authorised Service Centre.
Blades displaying the code indicated
on the Technical Data table should
be used on this machine.
Given product evolution, the blades listed
in the "Technical Data" table may be
replaced in time with others having similar
interchangeable and operating safety features.
9. STORAGE
IMPORTANT The safety regulations to
follow for putting into storage are described
in paragraph 2.4. Strictly comply with these
instructions to avoid serious risks or hazards.
9.1 STORING
When the machine is to be stored away:
1. remove the battery from its housing
and recharge it (para. 7.2.2);
2. when the cutting means has
halted, fit the blade guard;
3. allow the engine to cool before
storing in an enclosed space;
4. Clean (para. 7.3);
EN - 9