Maintenance Table; Troubleshooting - Stiga MH 900 Li 48 Manuel D'utilisation

The purchaser is protected by his or her own national legislation. The purchaser's rights under
the national laws or his or her own country are not in any way restricted by this warranty.

13. MAINTENANCE TABLE

Intervention
MACHINE
Check the status of the connection
cable of the battery backpack.
Check all fasteners.
Safety checks/command check.
Check the rods fixing.
Check the battery charge status.
Recharge the battery.
Clean the machine and the engine.
Cleaning and lubrication of the cutting means.
Checking for any damage to the machine. If
necessary, contact the authorised service centre.
Check the cutting means.
Sharpening the cutting means.
Replacing the cutting means.
* Refer to the battery/battery charger manual.
** The operation must be carried out by your Dealer or an Authorised Service Centre.

14. TROUBLESHOOTING

PROBLEM
1. The motor shuts down
whilst working.
Before each use.
Before each use.
Before each use.
Before each use.
Before each use.
After each use.
After each use.
After each use.
After each use.
After each use.
PROBABLE CAUSE
The connection cable is
not correctly inserted in
the battery backpack.
Battery is not inserted correctly.
Low battery.
Machine damaged.
EN - 14
Frequency
-
-
Check the correct connection of the cable to
the machine and to the battery backpack.
Make sure that the battery is correctly
inserted in the battery backpack (par. 7.2.3).
Check the charge status and
recharge the battery (par. 7.2.2), or, if
available, choose another battery.
Do not use the machine. Disconnect the
machine from the battery backpack and
contact an Authorised Service Centre.
Notes
-
para. 7.5
para. 6.2
4.3, 4.4
*
para. 7.2.2
*
para. 7.3
para. 7.4
-
para. 8.1.1
para. 8.1.2
**
para. 8.1.3
**
SOLUTION