Table Des Matières - Stiga MH 900 Li 48 Manuel D'utilisation

WARNING!: READ THIS MANUAL CAREFULLY BEFORE
EN
USING THE MACHINE. Keep safe for future use.
INDEX
1. GENERAL INFORMATION ..................................... 1
2. SAFETY REGULATIONS ........................................ 2
3. ABOUT THE MACHINE .......................................... 5
3.1 Machine description and intended use ........... 5
3.2 Safety signs .................................................... 5
3.3 Product identification label ............................. 6
3.4 Main components ........................................... 6
4. ASSEMBLY ............................................................. 6
4.1 Assembly components ................................... 6
4.2 Extension of the hedge trimmer ..................... 7
5. CONTROLS ............................................................ 7
5.1 Throttle control lever ....................................... 7
5.2 Throttle locking lever ...................................... 7
5.3 Cutting height adjustment button .................... 7
6. USING THE MACHINE ........................................... 7
6.1 Preliminary operations.................................... 7
6.2 Safety checks ................................................. 8
6.3 Start-up .......................................................... 8
6.4 Operation ....................................................... 9
6.5 Stop................................................................ 9
6.6 After use ....................................................... 10
7. ROUTINE MAINTENANCE ................................... 10
7.1 General Information ...................................... 10
7.2 Battery.......................................................... 10
7.3 Cleaning the machine................................... 11
7.4 Cleaning and lubrication of the cutting means
..................................................................... 11
7.5 Nuts and bolts .............................................. 11
8. OCCASIONAL MAINTENANCE ........................... 11
8.1 Cutting means occasional maintenance ....... 11
9. STORAGE ............................................................. 12
9.1 Storing .......................................................... 12
9.2 Storing the battery ........................................ 12
10. HANDLING AND TRANSPORT ............................ 12
11. ASSISTANCE AND REPAIRS ............................... 13
12. WARRANTY COVERAGE ..................................... 13
13. MAINTENANCE TABLE ........................................ 13
14. TROUBLESHOOTING .......................................... 14
15. ACCESSORIES ON REQUEST ............................ 15
15.1 Batteries ....................................................... 15
15.2 Battery charger............................................. 15
15.3 Battery backpack ......................................... 15
1. GENERAL INFORMATION
1.1 HOW TO READ THIS MANUAL
Some of the paragraphs in this manual contain
particularly important information in terms
of safety and operation, and are highlighted
differently, according to the following criteria:
DANGER
Failure to observe the warning can
lead to possible personal and/or third
party injury and/or damage.
ATTENTION
Provides details or further information
on what has been previously indicated
and aims to prevent damage to the
machine or cause other damage.
NOTE
Provides additional information unrelated to
dangerous or potentially damaging situations.
The paragraphs highlighted in a dotted grey
square indicate optional characteristics
not available on all models documented
in this manual. Check if the characteristics
are available on this model.
Whenever reference is made to a position on the
machine "front", "back", "left" or "right" hand side,
this refers to the operator's working position.
1.2 REFERENCES
1.2.1 Figures
The figures in these instructions for
use are numbered 1, 2, 3, etc.
Components shown in the figures
are marked A, B, C, etc.
Reference to component C in figure
2 is indicated with the wording: "See
fig. 2.C" or simply "(Fig. 2.C)".
The figures are provided by way of
example. The actual pieces can differ from
those illustrated in this document.
EN - 1