Troubleshooting - Pit Boss PBV3G1 Assemblage Et Fonctionnement

Proper cleaning and maintenance will prevent common operational problems. When your Pit Boss® smoker is operating poorly, or
used less frequently, the following troubleshooting tips may be helpful. For FAQ, please visit www.pitboss-grills.com . You may
also contact your local Pit Boss® authorized dealer or contact Customer Care for assistance.
WARNING: Prior to opening the smoker for any inspection, cleaning, maintenance or service work, ensure
the unit is completely cooled to avoid injury.
PROBLEM CAUSE
Burner Will Not Light The ignition wire is broken
No igniter spark on electrode
No gas supplied
Grease Fire / Frequent Grilling fatty meats
Flare-Ups
Cooking temperature
Water sprayed on gas flames
Burner blows out No Gas Flow
Gusting Or High Winds
Low heat on "HIGH" Ports blocked
Gas tank empty
Gas Leakage Improper Installation
Seal Failure
Regulator Failure
Burner Flames Are Poor Air Flow
Yellow Or Orange
Burner Obstruction
Grease Cup Is Full, Spilling
Regulator Valve Is Off
Burner Is Dirty

TROUBLESHOOTING

SOLUTION
Contact Customer Care for assistance or a replacement part.
Adjust the electrode. Contact Customer Care for assistance or a replacement part.
Check the regulator valve. Check connection for leak.
Grill fatty meats when the cooking surface is cold, and the knobs are on the "LOW" setting.
Attempt cooking at a lower temperature. Grease does have a flash point. Keep the
temperature under 176°C / 350°F when cooking highly greasy food.
Do not spray water on gas flames.
Check gas fuel connection, and ensure it is open. Replace gas cylinder if empty.
Turn front of grill away from wind or increase flame height.
Clear ports of any obstructions.
Refill the gas tank.
Turn the regulator knob to the OFF position, and allow the regulator knob to pop out. Remove
the gas cylinder. Re-install and tighten. Perform leak test to ensure proper seal. Replace gas
cylinder if damaged.
Gas cylinder has corroded, rusted, or has been mishandled. Replace gas cylinder.
Regulator needs to be replaced. Contact Customer Care for a replacement part.
Check burner tube and burner ports for spider webs or other obstructions. Follow Care and
Maintenance instructions to clean the burner tube.
Empty grease cup and re-install. Follow Care and Maintenance instructions.
Check the regulator valve connection to the gas cylinder. Remove, then reinstall. Perform leak
test.
Turn regulator knob to HIGH for five minutes, and burn-off the unit. Follow Care and
Maintenance instructions.
23