Mounting The Heat Indicator; Mounting The Cabinet Door Handle, Door Latch; Installing The Cylinder Retainer Bracket - Pit Boss PBV3G1 Assemblage Et Fonctionnement

10. MOUNTING THE HEAT INDICATOR

Parts Required:
1 x Heat Indicator (#5)
1 x Cabinet Door (#9)
Installation:
• Remove the washer and wing nut from the packaged Heat Indicator.
• Insert the Heat Indicator into the mounting hole on the front of the
cabinet door, place the washer on the thread pole on the inside of the
door, and hand-tighten by hand to secure.
NOTE: The Heat Indicator is supplied with one washer and one wing
nut.

11. MOUNTING THE CABINET DOOR HANDLE, DOOR LATCH

Parts Required:
1 x Cabinet Door Handle Gasket (#6)
1 x Cabinet Door Handle (#7)
1 x Cabinet Door Latch (#8)
4 x Screw (#C)
Installation:
• First, re-mount the cabinet door to the main cabinet by aligning and
securing both hinges. Ensure the door is mounted correctly by testing
it opens freely.
• Mount the cabinet door handle onto the front side of the cabinet door
using two screws. Note correct direction in 11A.
• Mount the cabinet door latch onto the exterior side of the main
cabinet using two screws. Note 11B.

12. INSTALLING THE CYLINDER RETAINER BRACKET

Parts Required:
1 x Gas Cylinder Retainer Bracket (#18)
4 x Screw (#B)
Installation:
• Mount Gas Cylinder Retainer Bracket onto the Main Cabinet using four
screws as shown in illustration.
10
9
5
11A
C
8
11B
12
B
C
C
6
7
18
11