Assembling & Installing The Wood Chip Tray; Mounting The Control Knob; Installing The Grease Tray; Looping The Zip-Tie - Pit Boss PBV3G1 Assemblage Et Fonctionnement

Fumoir vertical à gaz
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Parts Required:
13. ASSEMBLING & INSTALLING THE WOOD CHIP TRAY
Installation:
Parts Required:
1
x
Wood Chip Tray Lid (#11)
1
x
Wood Chip Tray Assembly (#12)
Installation:
1 . PLACI NG CONTROL KNOB INTO THE
Insert the wood chip tray lid into the lid slots on the wood chip tray
VALVE STEM
assembly and flip the lid down so it closes. Note illustrations in 13A.
Parts Required:
Slide the assembled wood chip tray into the opening above the front
control panel of the unit. Note 13B.
.
CONTROL PANEL
Installation:
Parts Required:

14. MOUNTING THE CONTROL KNOB

Parts Required:
1
x
Control Knob (#19)
Installation:
Mount the Control Knob to the front panel of the unit. Push the
Control knob firmly into the front panel until firmly seated.
IMPORTANT: Make certain to align the flat portion of the stem
with the flat portion of the Control Knob. This will ensure a proper
connection to the electrical components.
.

15. INSTALLING THE GREASE TRAY

CONTROL PANEL
19. LOOPING ZIP-TIE ONTO THE
Parts Required:
RIGHT FRONT LEG
Parts Required:
1
x
Grease Tray (#14)
Installation:
Parts Required:
Slide the Grease Tray into the opening below the front control panel
of the unit. Ensure the grease tray sits properly on the rails.

16. LOOPING THE ZIP-TIE

Parts Required:
19
19
1
x
Zip-tie (#F)
Installation:
Loop the Zip-tie through the outside edge hole of the front-right
Support Leg and around the regulator tubing.
NOTE: When the smoker is not connected to a gas supply, this will
assist in keeping the regulator head off the ground.
The unit is now completely assembled.
19. LOOPING ZIP-TIE ONTO THE
RIGHT FRONT LEG
Parts Required:
12
the Wood Chip Box Assembly (#12)
1 . PLACI NG CONTROL KNOB INTO THE
and slide Wood Chip Box onto the
VALVE STEM
Wood Chip Box support rails of Lower
Smoker Cabinet Assembly (#14) as
Fig.16 shown.
Parts Required:
Installation:
.
CONTROL PANEL
Parts Required:
19. LOOPING ZIP-TIE ONTO THE
RIGHT FRONT LEG
Parts Required:
19
19
13A
11
12
13B
12
14
19
15
14
16
F

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

1071977435

Table des Matières