Scheppach Basa 7.0 Traduction Du Manuel D'origine page 19

ment parts.
• Check the setting of the sawband guide regu-
larly and readjust it if necessary.
Remove the sawband guide for readjustment.
Failure
Motor does not start
Incorrect motor rotation direction
Sawband slips or jumps down
Burn marks on wood
Sawband jams
Troubleshooting
Possible cause
a) No current in the socket
b) Switch or capacitor defective
c) Electrical extension line defective
d) Incorrect connection line 3~400 V
e) Housing lid open (limit switch)
Incorrect connection
a) Upper band wheel
b) Saw band guide
c) Incorrect saw band
d) Fence not parallel to sawband
a) Sawband dull
b) Incorrect sawband
c) Incorrect cutting speed
d) Fence not parallel to sawband
a) Sawband dull
b) Sawband sticky with resin
c) Saw band guide
Solution
a) Check mains fuse
b) Have checked by electrician
c) Pull mains plug, check, replace
d) 5-line connection, at 1,5 mm² diameter
e) Close housing lid exactly
Reverse polarity of wall socket by electrician
a) Carry out side correction according to
Fig."9"
b) Set according to Fig. „10" and „11"
c) Select according to table
d) Set fence according to Fig. „4"
a) Replace sawband
b) Select according to table
c) Set cutting speed according to figure „6"
d) Set fence according to Fig „4"
a) Replace sawband
b) Clean sawband
c) Set according to Fig. „10" and „11"
19
D GB