Publicité
Les langues disponibles
Les langues disponibles
2610056733 02-21 PS31_PS31 2/15/21 12:41 PM Page 10
any assembly, adjustments or changing
accessories. Such preventive safety measures
reduce the risk of starting the tool
accidentally.
INSERTING BITS
Move reverse switch lever to the center
"OFF" position. Remove battery pack and
rotate the clutch ring to the drill bit symbol
"
". Rotate the chuck sleeve counter-
clockwise viewing from chuck end, and open
chuck to approximate drill bit diameter.
Insert a clean bit up to the drill bit flutes for
small bits, or as far as it will go for large bits.
Close chuck by rotating the chuck sleeve
clockwise and securely tighten by hand (Fig.
2).
PROTECTION AGAINST DEEP
DISCHARGING
The lithium ion battery is protected against
deep discharging by the "Electronic Cell
Protection (ECP)". When the battery is
empty, the tool is switched off by means of a
protective circuit.
VARIABLE SPEED CONTROLLED
TRIGGER SWITCH
Your tool is equipped with a variable speed
trigger switch. The tool can be turned "ON"
or "OFF" by squeezing or releasing the
trigger. The speed can be adjusted from the
minimum to maximum nameplate RPM by the
pressure you apply to the trigger. Apply
more pressure to increase the speed and
release pressure to decrease speed (Fig. 1).
FORWARD/REVERSING
LEVER & TRIGGER LOCK
prevent accidental starts and accidental
discharge.
Your tool is equipped with a forward/
reversing lever and trigger lock located above
the trigger (Fig. 3). This lever was designed
for changing rotation of the bit, and for
locking the trigger in an "OFF" position.
Assembly
Disconnect battery pack
from tool before making
Do not use the power of
the drill while grasping
Operating Instructions
After tool use, lock trigger
in "OFF" position to help
chuck to loosen or tighten bit. Friction burn
or hand injury is possible if attempting to
grasp the spinning chuck.
FIG. 2
CHUCK SLEEVE
SCREWDRIVER
BIT
SCREWDRIVER BIT
For forward rotation, (with chuck pointed
away from you) move the lever to the far
left.
For reverse rotation move the lever to the far
right. To activate trigger lock move lever to
the center off position.
Do not change direction
of rotation until the tool
comes to a complete stop. Shifting during
rotation of the chuck can cause damage to
the tool.
FIG. 3
-10-
BIT HOLDER
Publicité
