Installation - Klarstein 10034946 Mode D'emploi

INSTALLATION

Preparation of the Work Surface
• Cut out the work surface according to the sizes shown in the drawing.
• For the purpose of installation and use, a minimum of 50 mm space shall be
preserved around the hole.
• Be sure the thickness of the work surface is at least 30 mm. Please select heat-
resistant work surface material to avoid larger deformation caused by the heat
radiation from the hotplate. As shown below:
Note: The work surface material must use the impregnated wood or other insulation
material.
Installation Dimensions Hob
H
D
X
B
L (mm) W (mm)
290 520
L (mm) W (mm)
590 520
Under any circumstances, make sure the hob is well ventilated and the air inlet and
outlet are not blocked. Ensure the hob is in good work state (as shown below).
L
X
Model 10034946
H (mm) D (mm)
58 54
Model 10034947
H (mm) D (mm)
58 54
W
A
X
A (mm) B (mm) X (mm)
270 490 min. 50
A (mm) B (mm) X (mm)
560 490 min. 50
SEAL
X
EN
37