Ego Power+ BCA1200 Traduction De La Notice D'origine page 9

NOTICE:
The vibration emission during actual use of the
power tool can differ from the declared value in which the
tool is used; In order to protect the operator, user should wear
gloves and ear protectors in the actual conditions of use.
Recommended Blade
PART NAME
Brush Butter Blade
PACKING LIST
PART NAME
Brush Cutter Attachment
Blade and Blade Sheath Set
Guard
Guard Accessory (For use with trimmer
head ONLY)
Hex Wrench
Multi-Function Wrench
Operator's Manual
DESCRIPTION
KNOW YOUR BRUSH CUTTER ATTACHMENT (Fig. A)
1. End Cap
2. Brush Cutter Shaft
3. Guard
4. Blade
5. Blade Sheath
6. Clamp Wire
7. Sealing Screw
8. Gear Case
9. Shaft-locking Hole
10. Outer Flange
11. Multi-Function Wrench
12. Hex Wrench
13. Guard Accessory (For use with trimmer head ONLY)
WARNING:
Never operate the tool without the guard
firmly in place. The guard must always be on the tool to
protect the user.
WARNING:
When the tool is used as a line trimmer,
equipped with a trimmer head, the guard accessory
should be mounted onto the guard. Failure to comply could
result in an overly long cutting line and motor overload.
ASSEMBLY
WARNING:
do not operate this product until the parts are replaced.
Use of this product with damaged or missing parts could
result in serious personal injury.
MODEL NUMBER
WARNING:
or create accessories not recommended for use with this
ABB1203
brush cutter. Any such alteration or modification is misuse
and could result in a hazardous condition leading to
possibly serious personal injury.
WARNING:
QUANTITY
installing or removing the blade or the guard or doing any
1
maintenance on the blade. Be careful of the blade and
1 protect your hands from being injured by the blade.
1
WARNING:
assembly is complete. Failure to comply could result in
1
accidental starting and possible serious personal injury.
1
NOTICE:
1
cutter attachment is mounting the guard first, and then
1
the blade, and finally attaching to the power head.
WARNING:
and the front-assist handle with barrier bar firmly in place.
Failure to comply could result in possible serious personal
injury.
MOUNTING THE GUARD
Loosen and remove the two screws from the guard (Fig. C),
align the guard mounting holes with the assembly holes
and then lock the guard onto the shaft base with the two
screws, together with two spring washers (Fig. D).
Make sure the guard is fixed according to Fig. C & D, any
reverse fixing will cause great danger!
MOUNTING THE BLADE
1. The blade is shipped with a sheath. Before mounting
the blade onto the brush cutter, the sheath should be
removed by undoing the clamp wire from the hook on
the sheath (Fig. E).
Fig. E parts description see below:
BRUSH CUTTER ATTACHMENT — BCA1200
If any parts are damaged or missing,
Do not attempt to modify this product
Always wear heavy gloves when
Do not connect to power head until
The correct assembly sequence of the brush
Never operate the tool without the guard
E-1 Hook
E-2 Clamp Wire
EN
9