Publicité
Les langues disponibles
Les langues disponibles
tie-down straps into the locks.
NOTE: Keeping the cover in place any time the spa is not
in use will reduce the amount of time the heater operates,
thereby minimizing operating costs.
DANGER.RISK OF INJURY.
The power box must be connected at the point C.V. (see
installation set-up).Connecting the spa to an improperly wired
circuit will negate many of the spa's safety features. Improper
of injuries. Please read and follow the electrical installation
APPLICABLE NATIONAL AND LOCAL ELECTRICAL CODES.
EXPERIENCED, LICENSED ELECTRICIAN. WE RECOMMEND
WARNING: Removing or bypassing any GFCI breaker will
result in an un safe spa and will void the spa's warranty.
IMPORTANT:
your spa, it is essential
that you understand and apply these installation requirements.
Your spa has been carefully engineered to provide maximum
safety against electric shock. Remember, connecting the spa to
an improperly wired circuit will negate many of its safety features.
INSTRUCTIONS FOR CONNECTION
The spas are only provided in three-phase version (electric heater
or heat exchanger - OPTIONAL).
Five conductors are required (3 phases+neutral+earth) for the
The conductor sections must still consider not only the system
absorption, but also the cable paths and distances, the chosen
systems.
The spa is provided separated from the control unit (spa-pack)
which includes all electro-mechanical devices.
The compensation tank, which ensures the correct water level
maintenance in the spa, must be connected to the spa-pack
near the spa) must also be connected with the spa-pack.
NOTE: the compensation tank and the spa-pack, inclusive of
the electrical box, must be housed in an enclosed but ventilated
room, only accessible with the use of keys or tools and prohibited
to children or inexperienced people. Access to the various
devices for regular use of the spa (heating temperature setting,
be ensured.
personnel (system operator, maintenance operators):
this person is responsible for keeping the key to prevent
unauthorised access.
ATTENTION: The installer is responsible for choosing the
conductors with rated section and features suitable for
accessories (See CONNECTION DIAGRAM).
The cable path, the choice of materials and the most suitable
installation solutions are entrusted to the professionalism
ensuring and certifying the performed installation.
To ensure the degree of protection against water jets, provided
to facilitate connection with the electric network, regardless of
the section of the conductors used.
The installer must use a sheath with appropriate features, as well
AVOIDING THE RISK OF ELECTROCUTION
Risk of electrocution
supply. The spa must be connected to a Ground Fault Circuit
Interrupter (GFCI). Manufacturer does not supply a GFCI with
the spa. Manufacturer recommends the GFCI be attached to
the end of the spa's electrical cord. The GFCI must be installed
exceed all national and local electrical codes.
WARNING:
immediately. Failure to do so may result in death or serious
personal injury due to electrocution.
each use of the spa. If the GFCI does not perform properly, a
shock. Disconnect power to the spa until the fault has been
NOTE: Failure to wait 30 seconds before resetting the GFCI
may cause the spa's Power Indicator (on the control panel)
to blink. If this occurs, repeat the GFCI test procedure.
compartment containing the electrical components.
DANGER: RISK OF ELECTRICAL SHOCK
installed within 1.5 m of a metal surface if each metal surface
is permanently connected solid copper conductor attached to
the wire equipotential connector on the terminal box that is
provided for this purpose.
telephone, radio, or television within 1.5 m of a spa. Failure
to maintain a safe distance may result in death, or serious
personal injury due to electrocution, if the appliance should
fall into the spa.
electrical compartment and from all electrical components.
DO:
- use a licensed electrical contractor.
27
EN
Publicité
