Télécharger Imprimer la page

glass 1989 MySpa OF Notice D'installation, Utilisation & Maintenance page 26

Publicité

Les langues disponibles

Les langues disponibles

EN
failure to perceive heat, failure to recognize the need to exit the
spa, physicalinability to exit the spa, fetal damage in pregnant
women, and unconsciousness resulting in a danger of drowning.
WARNING: The use of alcohol, drugs, or medication can
greatly increase the risk of fatal hyperthermia in hot tubs
and spas.
TO REDUCE THE RISK OF INJURY:
temperatures between 38°C and 40°C are considered safe for
a healthy adult. Lower water temperatures are recommended for
extended use (exceeding ten minutes) and for young children.
Extended use can cause hyperthermia.
temperatures to 38°C. Failure to do so may result in permanent
injury to your baby.
AVOIDING THE RISK OF SKIN BURNS:
measure the water temperature with an accurate thermometer,
since the tolerance of temperature-regulating devices may vary
by as much as ±2°C.
it's comfortable.
IMPORTANT SPA INSTRUCTIONS
The following contains important spa information, and we strongly
encourage you to read and apply them.
DO:
is empty or full.
stated in this manual.
chemicals and cleaners.
DON'T:
in place. Exposure to direct sunlight can cause solar distress of
the shell material.
lift or carry the cover by using the handles.
serviceable parts inside. Opening of the control box by the spa
owner will void the warranty. If you have an operational problem,
carefully go through the steps outlined in the Troubleshooting
section. If you are not able to resolve the problem, contact your
authorized dealer. Many problems can easily be diagnosed over
the telephone by an Authorized Service Technician.
PRE-INSTALLATION REQUIREMENTS
IMPORTANT: given the high capacity and weight of the
and building services engineering study is necessary.
SITE PREPARATION
You probably have a spot picked out for your new spa, whether
it's indoors or outdoors, on a patio or on a deck. Just make sure
you check the following:
spa is very heavy. Make certain that the location you choose can
CAUTION: adjust the central feet of MySpa to ensure that
electrical components, in a place where water will drain away
from it. Allowing water into the equipment compartment can
damage the electronics, or may result in tripping your house's
circuit breaker.
care and maintenance.
INDOOR/BASEMENT INSTALLATION
Be aware of some special requirements if you place your spa
materials must provide a good grip when wet. Proper drainage
is essential to prevent a build-up of water around the spa. When
drain be installed. The humidity will naturally increase with the
spa indoors. Water may get into ironwork and produce oxide,
mildew, or other problems. Check for airborne moisture's effects
on exposed wood, paper, etc. in the room. To minimize these
effects, it is best to provide plenty of ventilation to the spa area.
An architect can help to determine if more ventilation must be
installed.
WARNING: Please keep the area around your spa well
To prevent the formation of condensation inside the space
around the bathtub, make a ventilation system having a
2
minimum area of 314cm
Inadequate ventilation around the spa could cause a build-up
of a higher-than-normal concentration of spa chemicals and/
or bacterial fragments. These dispersed spa chemicals and/or
bacterial fragments can be inhaled, and may result in breathing
compromised immune system or respiratory infection. If you or
other bathers are affected by this condition, please seek medical
attention as soon as possible.
In addition to the above, properly clean and maintain your spa
as follows:
instructions on all water care (chemical) products packaging.
pH, and other water care requirements.
schedule, and in accordance with this owner's manual.
spa water system.
SPA COVER INSTALLATION
of the spa so that they are easily reached by the cover tie-down
straps. Allow for about 1.5 cm to 2 cm of slack in the straps to
make it easy to insert straps into locks and to compensate for
vinyl shrinkage in cold weather.
26
. This system must be made in such a

Publicité

loading