Sony CDP-CX270 Mode D'emploi page 5

When connecting to an amplifier without a video input
jack
To an AC outlet
To LINE OUT To MONITOR OUT
To audio input
: Signal flow
What cords will I need?
Audio cord (1) (supplied)
White
(L)
Red
(R)
Video cord (1) (supplied)
Yellow
Hookups
When connecting the cords, be sure to match the color-
coded plugs to the appropriate jacks on the
components: Yellow (video) to Yellow, Red (right) to
Red and White (left) to White. Be sure to make
connections firmly to avoid hum and noise.
CD player
To video input
TV
To an AC outlet
Amplifier
To an AC outlet
White
(L)
Red
(R)
Yellow
When connecting to an amplifier with a video input jack
CD player
LINE MONITOR OUT
IN OUT
L L
R R
When connecting to an amplifier without a video input
jack
CD player
LINE MONITOR OUT
IN OUT
L L
R R
• If you have a Sony receiver (amplifier) equipped with
the CONTROL A1 jack
Be sure to connect the player to the VIDEO 2 jacks on the
receiver (amplifier). When making this connection, leave
the COMMAND MODE of the player to CD2 which is set at
the factory.
If you further connect the player and the receiver
(amplifier) via the CONTROL A1 jacks with the CONTROL
A1 cord (not supplied), you can use the Automatic Function
Selection feature between these components. For details,
refer to the supplementary "CONTROL-A1 Control
System" instructions and the instructions supplied with the
receiver (amplifier).
• If you have a Sony receiver (amplifier) with the
On-Screen Display Control function
You can control the player using the on-screen display and
the remote supplied with the receiver.
For details, see page 22.
• If you have a digital component such as a digital
amplifier, D/A converter, DAT or MD
Connect the component via the DIGITAL OUT (OPTICAL)
connector using an optical cable (not supplied). Take off the
cap and plug in the optical cable.
Getting Started Getting Started Playing CDs
Amplifier
VIDEO
VIDEO IN
AUDIO IN
TV
INPUT
VIDEO
L
AUDIO
R
Amplifier
CD
L
R
(Continued)
5 EN