Sony CDP-CX270 Mode D'emploi page 19

1
Press PROGRAM until the program number you
want (PROGRAM 1, 2 or 3) appears in the front
panel display.
If a program is already stored in the selected
program number, the last step of the program
appears in the front panel display. When you want
to erase the whole program, hold down CLEAR
until "ALL CLEAR" appears in the front panel
display (see page 20).
2
Turn the JOG dial until the disc number you want
appears in the front panel display.
PROGRAM1
CD2
*DISC-2O*
DISC TRACK
2O ALL
3
To program a whole disc, skip this step. Press
≠/± until the track number you want
appears in the front panel display.
PROGRAM1
CD2
*DISC-2O*
DISC TRACK
2O 3
Track number
4
Press ENTER or PROGRAM.
The track being programmed
PROGRAM1
CD2
*DISC-2O*
DISC TRACK
2O 3
The disc being
programmed
5
To program other discs/tracks, do the following:
To program
Other discs
Other tracks on the same disc
Other tracks on other discs
6 Press · to start Program Play.
To cancel Program Play
Press CONTINUE.
DISC
2 O
STEP
1
DISC
2 O
STEP
1
DISC
2 O
STEP
1
Playing order
Repeat Steps
2 and 4
3 and 4
2 through 4
The programs remain even after Program Play ends
When you press the · button, you can play the same
program again.
When you press PROGRAM during Continuous or
Shuffle Play
The program will be played after the current track.
The programs remain until you erase them
If you replace discs, the programmed disc and track
numbers remain. So, the player plays only the existing
disc and track numbers. However, the disc and track
numbers that are not found in the player or on the disc
are deleted from the program, and the rest of the
program is played in the programmed order.
When connected to the second player, you can
program tracks/discs of both players in the same
program
When selecting a disc, press PLAYER SELECT repeatedly
until "2nd PLAYER" appears in the front panel display.
Then select the disc you want to program.
Creating a program using the remote Z
DISC/CAPS
Number
buttons
CHECK
·
1
Press PROGRAM until the program number you
want (PROGRAM 1, 2 or 3) appears in the front
panel display.
2
Press DISC/CAPS.
PROGRAM1
CD2
*DISC-2O*
DISC-[
Getting Started Playing CDs Playing CDs
PROGRAM
TRACK/SPACE
ENTER
CLEAR
DISC
2 O
_]
(Continued)
19 EN