Ottobock 10R1 Instructions D'utilisation page 11

4.1.1 Connecting to a passive prosthesis hand:
• Connect the Light Metal Tube (13R3 / 13R4) or Modular Arm Component
(12R6=* / 12R7=*) to the 10R1 Adapter and screw the prosthesis hand
onto the adapter.
• Connect the 10R4=* Knurled Plate to the Adapter (10R2=* / 10R3=*).
• Connect the Light Metal Tube (13R3 / 13R4) or Modular Arm Component
(12R6=* / 12R7=*) to the Adapter (10R2=* / 10R3=*) and screw the
10R4=* Knurled Plate into the prosthesis hand.
4.1.2 Connecting to an Ottobock system hand or Ottobock hook:
• Connect the Light Metal Tube (13R3 / 13R4) or Modular Arm Component
(12R6=* / 12R7=*) to the Adapter (10R2=* / 10R3=*) and screw into the
Ottobock system hand or Ottobock hook.
5 Legal information
All legal conditions are subject to the respective national laws of the country
of use and may vary accordingly.
5.1 Liability
The manufacturer will only assume liability if the product is used in accor-
dance with the descriptions and instructions provided in this document.
The manufacturer will not assume liability for damage caused by disregard
of this document, particularly due to improper use or unauthorised modi-
fication of the product.
5.2 CE conformity
This product meets the requirements of the European Directive 93 / 42 / EEC
for medical devices. This product has been classified as a class I device
according to the classification criteria outlined in Annex IX of the directive.
The declaration of conformity was therefore created by the manufacturer
with sole responsibility according to Annex VII of the directive.
11