Configuring The Rs485 Board Microswitch; Installation On The Ingerev Fusion - Ingeteam INGEREV SMART DLM Manuel D'installation Et Configuration

INGEREV SMART DLM

5.1.2 Configuring the RS485 board microswitch

The 3rd pole of the switch connects the end-of-line resistor on the RS485 bus. Positions 1 and 2
activate the pull-up and pull-down resistors for devices with a Standard uncertainty threshold.
The RS485 board must have one of the following two configurations:
- The three poles in position ON.
- Poles 1 and 2 in position OFF. Pole 3 in position ON.

5.1.3 Installation on the INGEREV FUSION

The RS485 board connects to the lower slot on the control board.
Connection position of the RS485 kit on the FUSION control board.
ABW2012IQM01_B
Ingeteam
EN
ES
FR
IT
17