Ingerev Rapid - Ingeteam INGEREV SMART DLM Manuel D'installation Et Configuration

INGEREV SMART DLM

5.2 INGEREV RAPID

To communicate the external wattmeter with the INGEREV RAPID charging points, you need to use
the free RS485 connection on the unit.
This connector is shown in green below:
The RS485 connector pins correspond to these signals:
ABW2012IQM01_B
Pin Signal
1 NC
2 GND
3 RS-485 B (-)
4 RS-485 A (+)
Ingeteam
EN
ES
FR
IT
19