Installation; Installation On The Frame; Installing The Brake System - Marzocchi BOMBER 2003 Mode D'emploi Et Entretien

Masquer les pouces Voir aussi pour BOMBER 2003:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Installation

48
3
INSTALLATION
3.1

Installation on the frame

The fork is supplied with "A-Head Set" (threadless) steer tube to be cut according to frame size it will be
used on.
Installing a MARZOCCHI fork on the bicycle frame is a very delicate operation that must be carried out by
specialized personnel.
The assembling on the frame and the steer tube adjustment must be carried out in compliance with the
manufacturer's instructions. Improper installation may jeopardize the safety of the rider.
Marzocchi does not guarantee the installation and refuses all responsibility for damages and/or
accidents that may be caused by an incorrect installation.
The steer tube must be pressed into the crown;
its replacement must be carried out by one of
our service centers only, using the required
tools.
In case of improper installation of the steer
tube into the crown, the rider might lose control
of his/her bicycle, thus jeopardizing his/her
safety.
On the SHIVER DC model, the sliders are
clamped to the lower crown through some
bolts: before the installation on the frame, it is
therefore necessary to control the bolts
tightening, and to make sure that the distance
"D" between the lower crown and the tire end
(inflated) is total travel T+3 mm.
3.2

Installing the brake system

Assembling the brake system is a very delicate operation that must be carried out by specialized
personnel.
Marzocchi does not guarantee the assembly
and refuses all responsibility for damages and/
or accidents that may be caused by an
incorrect assembly.
Improper installation of the disk brake system
can overstress the caliper mountings, which
may break. The brake system assembling
must be carried out in compliance with brake
system's manufacturers instructions. Improper
installation may jeopardize the safety of the
rider.
Only use brake systems that are complying
with the fork's specifications, considering that:
• On Ø 32 stanchions forks and Upside down
forks you can exclusively assemble disk
brake systems.
A
A
B
B

Publicité

Table des Matières
loading

Table des Matières