Kettle - Beem Ecco 3 in 1 MF3450-A Mode D'emploi

3. Push the start button (5) down. The signal lamp on the button
toasting process begins.
4. Stop the toasting process with the button
process.
5. If you no longer need to use the bun rack (4), push the button (2) up. The bun rack
(4) folds back down.
6.2

Kettle

Hints and tips:
The filter (12) in the spout of the kettle (11) prevents lime scale residue etc. being
poured out with the water.
If the water cools down without being used, simply switch on the appliance again and
the boiling process will begin again.
If the kettle (11) is removed from the base station (13) before or during the boiling
process, the water boiling process stops and is continued again when the kettle is put
back in place.
NOTE: If the kettle (11) is switched on by mistake while empty, the boil dry
protection switches off the appliance automatically. Let it cool down before you
fill it with cold water and switch it on again.
NOTE: To avoid overload at the power connection, the kettle (11) switches off
automatically when the toaster is switched on. As soon as the toaster is ready,
the kettle switches back on again automatically.
1. Remove the kettle (11).
2. Open the lid (6) by pressing the button (7) and fill the kettle (11) with the desired
amount of water (at least 0.5 litres and a maximum of 1.5 litres).
NOTE: If there is too little water the appliance switches off before the water
boils.
CAUTION: Do not fill the kettle (11) above the MAX level. Water may overflow
and the heating element could become damaged. If the kettle (11) is overfilled
there is the risk of boiling water spurting out.
3. Make sure that the lid (6) is closed properly before you switch on the kettle (11).
6. The water boils quickly, then the on/off switch automatically switches off and the
signal lamps in the fill level indicator go out.
7. Lift the kettle (11) from the base station (13) to pour the water.
BEEM – Elements of Lifestyle
or wait until the end of the toasting
4. Place the kettle (11) on the base station (13). Turn it so
that the spout points towards the protrusion (a) and the
kettle (11) locks in place in the catch (b).
5. Push the on/off switch (8) down. The red signal lamps
in the water level indicator (10) light up.
CAUTION: Hot steam escapes when water is boiling.
Do not open the lid (6) of the kettle (11) when water
is being boiled or immediately after it has boiled.
NOTE: You can stop the boiling process at any time
by pushing the on/off switch (8) up.
lights up and the
27 / 72