Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation
Drainage connection
A water outlet hose is included with the machine.
This is attached to the machine's outlet and routed
to a floor drain or drainage pipe.
Note!
The height of the mouth of the outlet hose must
be lower than the lowest part of the outlet valve.
Part 2 Serial number < B0005202999
Electrical installation
The electrical connection must be made using a
cable for permanent installation, with a multipolar
circuit breaker, by a qualified professional.
Connection on delivery
The machine is supplied as 3-Phase, 400V, 50Hz,
heat output 3000W and has a 10A plug. Any
residual current devices must be type A.
Note!
Repairs and maintenance relating to safety or
performance must be carried out by a qualified
professional.
Coin operation
The machine is prepared for coin operation. Such
installation must be carried out by a qualified
professional.
The installation requires a connection cable to
power the coin meter. This connection cable can
be ordered as an accessory using the factory art.
no. 92 090 95.
The coin meter must be able to short circuit two
signal lines for periods of up to 10 minutes. This
is to give the user time to load the machine,
choose a programme and start the programme
after inserting the coins.
"Insert coin" appears on the display when the
machine is started with the main power switch.
21
Publicité
Chapitres
Table des Matières
Dépannage
