Installation; Positioning The Washing Machine; Adjusting The Feet; Connection To Water Supply - grandimpianti GH6V B0005203000 Manuel D'installation, De Maintenance Et D'utilisation

Installation

Positioning the washing machine

The washing machine can be installed as a
built-in or freestanding unit. Place the machine
on a firm surface with easy access to the plug.
A. Built-in
The washing machine can be installed under
a counter top with a working height of 850-900
mm. Leave a 5 cm space around the entire
machine, including between the rear edge of the
top cover and the wall behind it.
B. Freestanding
The washing machine can be positioned beside
or under a tumble dryer.

Adjusting the feet

Keep the noise that the machine produces to
a minimum by adjusting the feet so that the
machine is steady and balanced on the floor.
Tighten the lock nuts.
Locking nut

Connection to water supply

Water connection should be carried out by an
appropriately qualified person. Connect the
machine using the accompanying supply hose.
Water pressure should be 0.1–1 MPa (approx.
1–10 kp/cm ; 10–100 N/cm
2
stopcock on the water pipe.
If the pipes are newly installed, it may be wise
to flush them through so that any dirt is washed
away. Otherwise, dirt can clog the filter in the
machine's water intake and cut off the water
supply.
Part 1 Serial number > B0005203000
). There should be a
2
Use only the supply hose supplied with the
machine. Do not re-use old hoses or other loose
supply hoses.
Water intake
At the factory, the machine is set for connecting
to both hot and cold water supplies. The
machine can be set for cold water intake only.
See the section "Settings".
Hot water connection
A few seconds after you start a programme the
washing machine will begin to fill with water from
both the hot and the cold supplies. If for some
reason no hot water is available, the machine
waits for one minute and then fills with cold
water only. The wash drum does not start to
rotate until it begins to fill with water.
If the appliance is not connected to the hot
water line, then deactivate the function in the
User Menu.
(See chapter Settings.)

Drainage connection

A water outlet hose is included with the
machine.
This is attached to the machine's outlet and
routed to a floor drain or drainage pipe.
21