Fisher & Paykel ActiveSmart RF135B Guide D'utilisation page 29

To reset the filter indicator
Important!
We recommend the water filter to be used from the time of installation.
Do not reset indicator before filter is changed or filter monitoring will be inaccurate.
Press and hold and
■ ■
The icon on the internal and external displays will turn off when reset.
■ ■
To disable the filter indicator
Note: if disabled, you will not be reminded to next change your filter.
When no filter is fitted, you can disable the filter indicator.
■ ■
Press and hold
■ ■
We recommend that you do not disable the filter indicator if you have a filter fitted to the
■ ■
connection.
Important!
To avoid serious illness or death, do not use the water filter where water is unsafe or of unknown
■ ■
quality.
The water filter cartridge needs to be changed when the filter indicator icon flashes on the
■ ■
interface panel.
We recommend the water filter cartridge is replaced when the internal and external
■ ■
illuminate. This will happen every 6 months.
If the water filtration system has been allowed to freeze, replace filter cartridge.
■ ■
The rate of water flow through the water dispenser can slow down as the filter cartridge
■ ■
accumulates any sediment which may be present in the water supplied to your home. This varies
depending upon your local water quality, which may require your filter cartridge to be changed
more frequently.
In cases of excessively reduced filter life we recommend that you consult a local plumber or your
■ ■
water supplier for advice on suitable filtration requirements for the water supplied to your home.
Filter replacement is the consumer's responsibility and will not be covered by the warranty except
■ ■
in the case of faulty parts or materials within the filter cartridge.
If the water has not been dispensed for some time or water has an unpleasant taste or odor, flush
■ ■
system by dispensing 10 qt (10 liters) of water.
If unpleasant taste or odor persists, you may wish to fit a new filter cartridge.
■ ■
Water filter (Ice & Water models only)
for 4 seconds to reset the internal and external filter indicators.
and for 4 seconds to turn this feature off.
US
27
CA
icons