Fisher & Paykel ActiveSmart RF135B Guide D'utilisation page 14

Installation instructions
US
12
CA
Attach double sided foam to the back of the
11
water filter head as shown in Diagram 5. Write
the date to be replaced on the filter (date
installed + 6 months). Remove double sided foam
backing and attach filter to the desired position
as located in step 10 (refer to previous page).
Run the 1/4" (6 mm) tubing to back of the
12
refrigerator ensuring there is enough tubing to
pull out the refrigerator for service.
Remove compressor compartment cover by
13
removing screw at the top of each side of the
cover as shown in Diagram 6. Lift and tilt the
compressor compartment cover to remove as
shown in Diagram 7.
Connect tubing into the water (solenoid)
14
valve located on the right hand side of the
unit (compressor) compartment as shown in
Diagram 8. Beware of hot pipes.
Pull gently on tubing to ensure it is locked in as
15
shown in Diagram 9.
Place compressor compartment cover back into
16
position, run the 1/4" (6 mm) tubing through
the space provided at the top right hand side
of the compressor compartment cover in an
upward direction and rescrew the compressor
compartment cover.
The completed installation should look like
17
Diagram 11 on page 13.
Turn isolating faucet on and check that all
18
connections are dry and free of drips.
Coil water line tubing behind the refrigerator.
19
Push your refrigerator into place being careful
not to kink or squash the water line running into
the water (solenoid) valve.
Read pages 13 – 14 carefully and then turn
20
refrigerator on.
Diagram 5
Fig.7 Double sided
foam attachment
Diagram 6
Diagram 7
Diagram 8
Fig.8 Waterline connection to refrigerator
Diagram 9