Fisher & Paykel ActiveSmart RF135B Guide D'utilisation page 16

Installation instructions
US
14
CA
Before you start using your Ice & Water refrigerator
Check your refrigerator is switched on and has cooled for at least 2 hours before use (refer to
■ ■
page 21 – The temperature of your refrigerator and freezer).
Check that the isolation tap has been connected and turned on.
■ ■
The first time you use your water dispenser, there will be a 1 – 2 minute delay while the tank
■ ■
fills until water is dispensed. Run through and discard the first 3 qt (3 liters) of water, stopping
intermittently to remove trapped air in the system. Failure to do this will result in excessive
dripping from your dispenser.
Turn the ice maker on by pressing the
■ ■
will be illuminated when the ice maker is on.
Press and hold the
■ ■
refrigerator compartment door to force an ice maker cycle. The ice tray will flip twice. Repeat to
force another ice maker cycle. The ice tray will flip twice and spill water into the ice bin. Empty
the water, dry and replace the bin. Note that the ice tray will not flip until the refrigerator
compartment door is closed.
Please discard the first 3 harvests of ice (8 cubes per harvest).
■ ■
You are now ready to enjoy ice and water from your ActiveSmart™ refrigerator.
Please note that once installation is complete a few drips may appear out of the dispenser over
the next few days as the remaining trapped air is cleared.
button (refer to pg 28). The light above the
, and buttons together for 4 seconds and then close the
Fig.10 Water dispenser
button