Power Supply - Sharp EL-1611E Mode D'emploi

POWER SUPPLY

This calculator operates on dry batteries.
The calculator can also be operated on AC power through use of an
AC adaptor.
BATTERY OPERATION
If the display becomes dim or the printer stops before or during
printing, the batteries should be replaced.
Battery: Heavy-duty manganese battery (AA or R6) × 4
1. Turn off the power by pressing .
OFF
2. Remove the battery cover by sliding it in the direction of the
arrow on the cover.
3. Replace the batteries. Be sure that the "+" and "–" marks on the
battery correspond to the "+" and "–" marks in the calculator.
Always put back the 4 batteries at the same time.
4. Put back the battery cover.
98305_EL-1611E(LC7)_Eng.pm65 7
5. After the replacement, press and
OFF ON
the calculator.
When the batteries are correctly installed "0." will be displayed.
(If the display is blank, displays any other symbol or the keys
become inoperative, remove the batteries and install them again.
Press and in this order and check the display again.)
OFF
ON
Note: Due to solvent leakage of the battery, keeping a used battery
in the battery compartment may result in damage to the
calculator. Remove a used battery promptly.
Battery cover
0.3.6, 1:24 PM
in this order to clear
7