Connecting To An Iphone - Tanita InnerScan DUAL Manuel D'utilisation

Connecting to an iPhone

1.
Turn the Bluetooth setting on, and use the URL to download the Health Planet app.
www.tanita.eu/RD901applicationdownload
Note:
・See the Tanita website for details on supported models.
・If you do not wish to use the dedicated app, configure the settings manually
on the body composition monitor. (P.8)
・You need to register your iPhone again if you replace your iPhone.
2.
Launch the app. You need to register as a member to use the Health Planet app.
After registering, login with your registered details.
3.
Select "Input Data", then select "Input from BCM".
Note:
• When taking measurements while holding your iPhone, enter the weight
that you want to subtract into the "Smartphone's weight" section in the dedicated
app before taking measurements.
• The weight that you entered to be subtracted from your weight is displayed.
・The "Smartphone's weight" can be entered up to -2.00kg (-4.4lb, -4lb).
・The maximum weight (weighing capacity) is reduced by the amount entered for the
"Smartphone weight".
4.
Check the Body Composition Monitor is off, and tap the "Add Device" button.
Note:
• The approximate communication distance is 5m in an unobstructed location.
5.
Follow the instructions on the app, and press and hold the
on the Body Composition Monitor for 3 seconds.
Note:
• When registering your body composition, place the Body Composition Monitor on a hard,
flat floor and step on it with bare feet.
6.
Follow the instructions on the app and measure your body composition.
When measurement is complete, the connection to the iPhone is disconnected.
The screen displays and instructions may differ depending on the app specifications.
(communication) button
7