How To Determine Body Fat Percentage; Taking Weight Measurement Only; Troubleshooting - Tanita BF-522 Mode D'emploi

GB

HOW TO DETERMINE BODY FAT PERCENTAGE

1.Set Age
Press the SET button to turn on the power.
The display defaults to Age 30.
Use the Up/Down buttons to scroll through numbers.
When you reach your age, press the SET button.
The unit will beep once to confirm.
Note : Range of user age is between 7-99 years.
Note : If you make a mistake or want to turn the unit off before you have
2. Select Female or Male
Use the Up/Down buttons to scroll through Female (
Female/Athlete and Male/Athlete settings, then press the Set button. The
unit will beep once to confirm.
3. Specify the height
The display defaults to 5'7.0"(170cm).
Use the Up/Down buttons to specify Height and then press the SET button.
The unit will beep once to confirm.
Range of user is from 3' 4.0" – 7' 3.0" or 100cm – 220cm.
Note :
4. Get your Readings
The unit will beep twice and "0.0" will appear on the display screen.
Make sure you are barefoot before stepping on scale.
Step on to the platform when "0.0" appears.
Your weight will be shown first.
Continue to stand on the platform.
"00000"will appear on the display and disappear one by one from left to
right. Your body fat percentage (%FAT) will appear on the display screen.
The display will flash your weight and %FAT alternately 3 times, then the
power will automatically turn off.
Note : If you step onto the platform before "0.0" appears, the display will show "Error" and
you will not obtain a reading. Furthermore, if you do not step onto the measuring
platform within about 60 seconds after "0.0" appears, the power will shut-off
automatically.
Note: Do not step off until Body Fat % is shown.
7
finished programming it, press button to force quit.
) or Male (

TAKING WEIGHT MEASUREMENT ONLY

Press the button when the unit is off.
When 0.0 appears on the display screen, step on the platform. Your weight
will appear on the display and continue to flash as long as you remain on the
platform.

TROUBLESHOOTING

If the following problems occur ...then...
• A wrong weight format appears followed by kg, lb, or st-lb
Refer to "Switching the Weight Mode" on p.6.
• "Lo" appears on the display, or all the data appears and immediately
disappears.
),
Batteries are low. When this message appears, be sure to replace the batteries immediately, since weak batteries will
affect the accuracy of your measurements. Change all the batteries at the same time with new AA-size batteries.
Note: Your settings will not be erased from the memory when you remove the batteries.
• "Error" appears while measuring.
Please stand on the platform keeping movement to a minimum.
The unit cannot accurately measure your weight if it detects movement.
• The Body Fat Percentage measurement does not appear or "-----" appears
after the weight is measured.
Make sure socks or stockings are removed, and the soles of your feet are clean and properly aligned with the guides
on the measuring platform.
• "OL" appears while measuring.
Reading cannot be obtained if the weight capacity is exceeded.
• "Err C" appears after power on.
The problem might be caused by the connection between the display box and the platform.
If this problem happens, please contact Customer Service.
GB
8