Troubleshooting; Poor Draught Of The Stove; The Stove Heats Poorly; The Stove Irradiates Too Much Heat - Storch Kamine ASKJA E EX Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Small cracks in the fire brick are inevitable due to the heat load and under the conditions of normal use they do
not have any impact on the functionality and service life. In case of bigger damage contact an authorized retailer.
In regular intervals check the door gasket for damage and replace it if necessary.
Painted surfaces should be cleaned with a soft, dry cloth - never use abrasive means, fat solvents, wet cloths, etc.
Please, note that in spite of the painting the stove does not have a non-corrosive design!!!
7.

Troubleshooting

7.1

Poor draught of the stove

Is the flue too low or is the cross-section unsuitable?
Are there leaks in the flue or the stove pipe?
7.2

The stove heats poorly

Is the room too large for the stove?
Is the ashpan full?
Is the smoke exhaust clogged?
Are the combustion air controllers closed?
Is the connection of the stove to the flue sealed?
7.3

The stove irradiates too much heat

Are the combustion air controllers opened completely?
Is the stove door completely closed? Is the ashpan fully closed?
Is there too much fuel in the chamber?
8.

Fire protection

Please, instruct especially your children about this danger and during the heating operation of the stove
keep your children as far as possible. Burning of wood causes strong heating of the stove surface as well as
the control elements, but above all of the glass and the flue gas pipe. Never touch these parts without
corresponding protective clothing or aids as e.g. heat-resistant gloves. Do not put articles or clothing or
other item on the stove to dry. It is prohibited to put objects that are not heat-resistant on the stove or in its
vicinity. Put laundry drying stands or similar structures in a sufficient distance from the stove. Heating or
inserting of highly flammable or explosive substances as empty spray cans, etc. in the combustion chamber
or their storage in the immediate vicinity of the stove is strictly prohibited due to the risk of explosion.
When loading wood, do not wear loose or highly flammable clothes. During operation of your stove
processing of highly flammable and explosive substances in the same or adjacent rooms is forbidden.
9.

Guarantee

Remember to read the attached guarantee certificate before you put your stove in operation. It
contains information about obligations that must be met for possible guarantee claims to be
recognized.
The guarantee does not cover damage caused by incorrect operation.

10. Wood-burning stove installation

10.1 Requirements for the installation place

The wood-burning stove may only be installed in rooms and places where no risks result from the position,
structural conditions and way of use. For proper operation of the stove the area installation room must be laid out
in such a way and be large enough to ensure supply of enough combustion air any time.
The installation of the stove is subject to local building regulations and fire protection rules. In this respect,
you can ask your local chimney supervisor for necessary information. This supervisor also approves
connection of the stove to the flue.
- 18 -

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Askja he exAskja bfe exAskja e seAskja he se

Table des Matières