Drive Covering, Chassis Bridge - Reely ROAD Ranger Notice D'emploi

k) Drive covering, chassis bridge
S7
M3 x 15mm
S2
S1
S4
S1
M3 x 10mm
CB1
S1
EH1
GA1
AN1
S2
HA2
HA1
First mount the two short retaining pins "HA1" and the long
retaining pins "HA2" on the chassis, use counter-sunk self-
tapping screws with a thread length of 8mm.
HA1
HA1
Afterwards, the chassis bridge "CB1" can be attached.
The two "S4" screws (M3x10mm) are screwed to the
attachments for the steering lever.
The two "S7" screws (M3x15mm) are screwed through the
chassis bridge and the gear cover to the motor attachment.
Two long self-tapping screws "S2" (thread length 15mm) are
HA2
to be attached to the differential housings front and rear.
Finally, 5 additional self-tapping screws "S1" (thread length
EH1
10mm) are screwed to the retaining pins and the receiver
mount "EH1" thus completing the mounting of the chassis
bridge.
The "AN1" attachment for the antenna tube is inserted between
"HA2" and "CB1".
61