Testing Of Steering Function With The Help Of Transmitter; Mounting Of Drive Battery - Reely ROAD Rhino 23 60 49 Notice D'emploi

b) Testing of steering function with the help of transmitter
If the front wheels are turning left although you steered towards the right on the transmitter, you have to change the
direction of steering of the steering servo with the servo reverse function on the remote control transmitter.
If the steering on the vehicle already responds strongly to a slight steering on the transmitter, choose a steering point
for the steering rods that is further on the inside on the lever of the steering servo.
Our tip:
Always try to set the mechanics optimally first before you limit the servo path electronically with trans-
mitter functions such as end point adjustment (EPA) or dual rate (D/R).
c) Mounting of drive battery
To install the battery pull off both retaining clips (1) and lift
the mounting brace (2) out towards the top.
Now place the rechargeable battery into the chassis and
replace the mounting brace. The securing of the mounting
brace is then taken on by the two retaining clips again.
The battery recess is designed for many different types of
rechargeable batteries.
Next to in-inline soldered racing packs (see picture), battery
packs with cells that are aligned in parallel can also be used.
In this case the mounting brace has to be put in with the top
side pointing downward.
Even 7-cell racing packs can be used when the mounting
brace (3) on the back is taken off and the back chassis drill-
ing (4) is put back in.
Warning!
The rechargeable battery pack must not yet be connected to the cruise control/receiver.
28
Figure 2
Figure 3