Removing The Car Body; Installing The Receiver Aerial Cable; Attaching The Telescopic Aerial To The Transmitter - Reely ROAD Titan Notice D'emploi


8. Bringing into Service
a) Removing the Car Body
The car body is secured with fastening clamps (so-called car body splints) that must be pulled from the holding pins.
The car body can then be lifted off.
b) Installing the Receiver Aerial Cable
With 27/40MHZ remote controls, the receiver's aerial cable is normally rolled up on delivery of the model car. Unwrap
the aerial cable completely and smoothen it carefully. For this, hold the aerial cable near the receiver with two fingers
(do not hold the receiver but the cable) and then pull the cable straight repeatedly with two fingers of your other hand.
Now insert the aerial cable from below through the attachment (possibly already performed by the manufacturer).
Guide it through the aerial tube and plug the aerial tube into the respective attachment mount on the vehicle. Simply let
excess aerial cable protrude loosely from the tip of the aerial tube.
If a rubber cap for the aerial tube is enclosed, it prevents the dislocation of the aerial cable after it is attached to the tip.
Make sure that the aerial cable does not protrude into the drive or touch the cardan shaft! It is normally
sufficient to slightly tighten the cable or fix it in place with a cable binder.
Never shorten the aerial cable! Never roll up the aerial cable! This greatly reduces the range.
c) Attaching the Telescopic Aerial to the Transmitter
With 27/40MHZ remote control systems the transmitter has a telescopic aerial. If the telescopic aerial is included
separately (and not already screwed into the transmitter), insert it into the corresponding opening on the transmitter
from above and screw it tight by hand. Do not use any force when screwing the aerial in; do not use any tools!
All manuals and user guides at all-guides.com
39