Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
12.
Crystal Change
There must be no other transmitters/models with the same frequency in the range of the transmitter, because the
transmitters interfere with each other. As a result, the models no longer respond correctly to the transmitter com-
mands. If there are any other model vehicles in your range, talk to the other operators about the frequencies they use.
For safety reasons, you should only use crystals that are explicitly recommended by the supplier for use in
your remote control system.
• Before a crystal change, turn off the speed controller first and then the transmitter. Then separate the rechargeable
driving battery from the speed controller and completely remove the plug connection.
• Pull the crystal out of the transmitter.
• Insert a transmitter crystal with a different channel (in the same frequency band) into the transmitter. It does not
matter which way around the crystal is.
Please ensure that you place the correct crystal in the holder. Transmitter crystals are normally labelled "T"
or "TX" (T = "transmitter").
• Pull the receiver crystal out of the vehicle's receiver.
• The crystal suitable for the receiver has to be marked with the same channel name as the transmitter crystal. In
addition, it is labelled "R" or "RX" (R = "receiver").
• Insert the receiver crystal into the receiver. Orientation is also unimportant here.
• Switch on the transmitter and then the receiver and check the function of the speed controller and the steering
system; perform a range check.
All manuals and user guides at all-guides.com
55
Publicité
Table des Matières
