Operation; Removing The Car Body; Installing The Receiver Aerial Cable - Reely ROAD Leopard Notice D'emploi

Masquer les pouces Voir aussi pour Leopard:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles



8. Operation

a) Removing the Car Body
The car body and rear spoilers are secured with fastening clamps that must be pulled from the holding pins. Then, first
the rear spoiler and then the vehicle body can be lifted off.
b) Installing the Receiver Aerial Cable
For 27/40 MHz remote control systems, the receiver's aerial cable is normally rolled up on delivery. Unwrap the aerial
cable completely and smoothen it carefully. For this, hold the aerial cable near the receiver with two fingers (do not
hold the receiver but the cable) and then pull the cable straight repeatedly with two fingers of your other hand.
The receiver and the aerial cable are located in the receiver box, which is closed with 4 screws. Therefore,
first open the receiver box lid by removing the 4 screws. Then you can uncoil the aerial cable and feed it
through the holder in the receiver box lid.
To protect the receiver from vibration, we recommend wrapping it in foam before closing the receiver box
again.
Now insert the aerial cable from below through the attachment (possibly already performed by the manufacturer).
Guide it through the aerial tube and plug the aerial tube into the respective attachment mount on the vehicle. Simply let
excess aerial cable protrude loosely from the tip of the aerial tube.
If a rubber cap for the aerial tube is enclosed; it prevents the dislocation of the aerial cable after it is attached to the tip.
Make sure that the aerial cable does not enter the drive. Never shorten the aerial cable! Never roll up the
aerial cable! This greatly reduces the range.
c) Inserting the Driving Batteries in the Vehicle
Pull off the two safety clips on the battery holding retainer and then lift them off.
Insert the driving batteries into the chassis battery holder and then attach the retainers with the safety clips previously
removed.
Attention!
The driving battery must not be connected to the speed controller yet.
36

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

23 78 52

Table des Matières