Attaching And Fastening The Car Body; Steering Of Vehicle - Reely ROAD 23 52 11 Notice D'emploi

All manuals and user guides at all-guides.com
i) Attaching and fastening the car body
Guide the tube of the antenna from underneath the car body through the hole intended for that purpose.
Now put the car body on the holders and fasten the vehicle lining with the safety clips removed at the start.
Your car is now ready for its first test run.
j) Steering of the vehicle
Operate the throttle for the drive function very cautiously and do not drive too fast at the beginning until
you get used to the reactions of the car.
Do not make quick jerky movements on the operating elements of the remote control.
If the vehicle shows a tendency to pull towards the left or the right, set the steering trim on the transmitter accordingly
(trim control "ST.TRIM").
When changing between going forward and reverse, the throttle has to be briefly (approx. 1 second) in the centre
position (centre position = motor not moving). When the throttle is directly pushed from forward to reverse, the brake
function of the drive takes place (vehicle will NOT go reverse).
For example:
1. Release throttle, vehicle is rolling to a halt (or doesn't move).
2.Drive forwards, slowly pull the throttle towards the handle
3.Going forward and then braking (vehicle decelerates; does not roll slowly to a halt); slide throttle away from the grip
4.Going forward and then going reverse (wait briefly between change!)
32
Wait briefly