Getting Started With The Model Vehicle; Connecting Drive Battery - Reely ROAD Rhino 23 60 49 Notice D'emploi


9. Getting Started
 with the Model Vehicle
a) Connecting drive battery
Before connecting the drive battery with the cruise control, start using the remote control transmitter and check the
function of the transmitter in accordance with the instructions for use.
To prevent a sudden starting of the wheels and therefore an
uncontrolled starting of the model, place the model vehicle
on a suitable wooden block (1) or similar, so that the wheels
can turn freely in case there is a fault scenario.
Now connect the drive battery with the cruise control with
the help of the plug (2) that is protected against polarity re-
versal.
Slide the cruise control switch in the "ON" position and check the drive and steering functions as well as the necessary
trim values of your vehicle in accordance with the instructions of the operating instructions of the remote control.
If the electric motor does not stop when the operating lever for the drive function is in the centre posi-
tion, the servo path on the transmitter has to be programmed on the mechanical cruise control and/or
the steering rods have to be changed.
When using an electronic cruise control, the cruise control has to be programmed.
Figure 4
29